devices for the user

we think about your well-being

The manual control unit is easy-to-use, intuitive and easy to program, it has the following specifications:

Wall placement.
Supply: 2 AA batteries, with 1 year of autonomy if the are alkaline.
Operation modes: AUTO, Manual and OFF.
Weekly programming with a 60 minute intervals (30 minutes by app), and 3 possibilities of temperature (Comfort, Eco, Anti-frost).
70x44mm LCD size, Bar programming indicator de programación 2×24 pixels, 4 digits for hour-temperature, showing weekday and icons. Backlight LED.
Temperature sensor NTC 10K 1%.
Temperature accuracy 0.1ºC, setup temperature 0.5ºC steps, from 0ºC to 35ºC.
8 buttons. Keyboard tamper protection in order to be only used in a remote way..
Relay, capacidad 6 A 250V. NO and NC contacts, in order to work on gas boiler, pellets, diesel oil, propane and central heating.
Temperatura control by PI-selectable periods /selectable hysteresis .
Non Volatile Memory for storage data without supply.
Radiofrequency communication with confirmation (sent and reception) 868MHz. Integrated antenna. 200m transmision in open field, 30m inside buildings.
Hidden Configuration Menu (Heat /Cold device, low battery antilock protection, control type PI / Hysteresis, Antiseizing protection, Temperature units ºC o ºF).

The energy meter carries the entire calculation of the total energy consumption of the installation (as the smart meter does). It registers the figure in the equipment memory to compose the different electricity records.

DIN rail installation. 1 necessary unit.
External current sensor, with 3.5mm jack connector for easy installation.
Power supply 200-260V , 50Hz.
Consumption 0.65W.
Radiofrequency communication with confirmation (sent and reception) at 868MHz.
Integrated Antenna. 200m range in open field, 30m inside buildings.
Measuring: 1. Voltage, Current up to 100A-AC 2. Instantaneous Active Power. It calculates the real active power, considering electricity voltage, current and the delay between phases. 3. Accumulated active energy, the same as the previous one. 4. Possibility of measuring power and reactive energy as the power factor and frequency. 5. Error <3%. (internal tests reflected about a 1% measure) 6. Size capacity of cable: ø12mm, maximal commercial section 95mm2) 95mm2.

Termoweb center

The heart of the termoweb system is in charge of interconnecting all gadgets and recording the data.

Wall or table installation.
Power supply: external power supply, 5V 500mA.
Consumption 300mA.
Dimensions: 80x80x22mm.
RJ45 connector for Ethernet connections .
Status LEDs.
Radiofrequency communication with confirmation (sent and reception) at 868MHz.
Integrated Antenna. 200m range in open field, 30m inside buildings.
Data send to an external server, to communicate with the installation without need to redirect ports.
JSON data packaging with authentication.
Automatic remote firmware update through internet.
Time synchronization by NTP server, the hour is synchronized in all connected gadget.

Electric Heaters

Several brands use the termoweb technology in the electronics to control their electric radiators allowing the configuration, the control and the revision of records of consumption and temperature.

Integration in electric radiators.
Load control by Triac.
Current sensor onboard.
Record of accumulated consumptions and average temperatures by termoweb centre.
Possibility of keyboard tamper protection in order to be only used in a remote way.